Best current price£9.99from eBay
Shopping.co.uk recommended and popular offers
eBay£9.99Visit shop 4pcs E64 Motor Carbon Brushes 1619P11715 for Bosch GWS 750, 750 S & 750-115
Visit shop
B&Q£10.99Visit shop B&Q - 4Pcs E64 Motor Carbon Brushes 1619P11715 For Bosch Gws 750750 S & 750-115 Angle Grinder
Visit shop2 offers from £9.99 - £10.99
View price history by clicking the chart icon.
The OKODOKO E64 motor carbon brushes are essential maintenance components designed for DIY enthusiasts and professionals using Bosch GWS 750 series angle grinders to restore motor efficiency and extend tool lifespan. These brushes provide a cost-effective way to fix power delivery issues caused by worn-out contacts, though users must be careful to verify their existing brush dimensions before installation to ensure compatibility.
| Model Part Number | 1619P11715 |
|---|---|
| Brand | OKODOKO |
If your tool loses power, sparks more than usual, or fails to turn on despite being plugged in, the brushes are likely worn down.
You typically only need a standard screwdriver to open the tool housing.
These are high-quality aftermarket replacements designed to function as a compatible alternative to the 1619P11715 part.
The package includes 4 individual pieces.
These are specific to the GWS 750, 750 S, and 750-115 series. Check your manual or existing brush dimensions before use.
Yes, carbon brushes naturally wear down into a fine black dust during normal operation.
Check that the terminal springs are seated correctly and the electrical wire is firmly attached to the spade connector.
Ensure the brushes are inserted in the correct orientation and that the commutator surface is clean and free of debris.
Before starting, ensure the power cord is unplugged from the outlet. Use a screwdriver to remove the rear housing screws to access the brush holders. Gently unclip the existing brushes and replace them with the new units, ensuring they slide freely within their tracks. After installation, it is recommended to run the tool at low speed for a few minutes to allow the brushes to seat properly against the commutator. Always check that the dimensions (15.5 x 8 x 5mm) match your current brushes before proceeding.
