Blackmagic Design 2110 IP Converter 3x3G - CONVNVIPA3/3G

The converter supports video modes up to 1080p60.

The converter has three independent SDI inputs and three independent SDI outputs. Each input has a loop output, meaning you can connect up to 6 unique SDI devices in total (3 inputs, 3 loop outputs).

It uses a 10 Gigabit Ethernet connection with an RJ-45 connector for copper cables (Cat6 or higher) or an SFP socket for optical fiber modules.

Yes, the RJ-45 port supports 10/100/1000/10G BASE-T and can receive power via PoE+ when connected to a compatible network switch using Cat6 copper cables.

It supports up to 16 channels of embedded audio per video stream.

It uses SMPTE ST-2110 standards, including support for PTP (Precision Time Protocol) for precise timing synchronization. It also features a reference output timed to the PTP clock.

The converter is compatible with Mac OS X 10.15 Catalina, macOS 11 Big Sur, and Windows 10.

Verify the external power adapter is securely connected to both the device and a working power outlet. If using PoE+, ensure your network switch supports and is configured for PoE+ output on the port used.

Confirm that the SDI input signal is active and at a supported resolution (e.g., 1080p60). Check the IP configuration (IP address, subnet mask, gateway) on the converter and ensure it matches your network settings. Verify the 10G Ethernet cable is securely connected and functioning.

Ensure that the SDI input signal includes embedded audio. Check the audio channel mapping settings on the converter's front panel menu and verify that up to 16 channels are enabled if required.

Confirm that PTP (Precision Time Protocol) is enabled and correctly configured on both the converter and your network switch. Ensure your network is not congested and has adequate bandwidth for the video streams.

Try power cycling the device by disconnecting and reconnecting the power source. Ensure the front panel buttons and spin knob are clean and free of debris.