Self Adhesive Caulk Sealant Tape - 3 Rolls - 38mm x 3.2m

Best current price£13.49from B&Q
Best offers
Shopping.co.uk recommended and popular offers
B&Q£13.49Visit shop - 3 Rolls Clear Self Adhesive Caulk Sealant Tape 38mm X 3.2M
Visit shop
Best current price£13.49from B&Q
Shopping.co.uk recommended and popular offers
B&Q£13.49Visit shop - 3 Rolls Clear Self Adhesive Caulk Sealant Tape 38mm X 3.2M
Visit shop2 offers from £13.49
View price history by clicking the chart icon.
This 3-roll set of KDMD self-adhesive caulk sealant tape is designed for homeowners and DIY enthusiasts looking to create a watertight, hygienic seal around bathroom and kitchen fixtures. It is an excellent solution for preventing water ingress and grime buildup in joints and corners, though users must ensure surfaces are perfectly dry and clean to ensure the adhesive creates a reliable bond.
| Model Part Number | 5063886913937 |
|---|---|
| Brand | KDMD |
Yes, it is designed for use around gas stoves, but ensure it is applied to the seam joints and not directly on heating elements.
Yes, the material is waterproof and specifically designed to prevent water ingress in wet areas like showers and sinks.
The pack contains 3 rolls, with each roll measuring 38mm in width and 3.2 meters in length.
No, the tape is designed to be self-adhesive. It is meant to be a cleaner alternative to messy silicone tubes.
Yes, it can be removed, but you may need to use a adhesive remover or warm it with a hairdryer to soften the glue for easier removal.
The surface likely had residual moisture or grease. Clean with rubbing alcohol, let dry, and reapply using heat for better adhesion.
Use a hairdryer to warm the tape; the heat makes the material more pliable and activates the adhesive for a tighter corner fit.
To ensure maximum effectiveness, follow these steps during setup: 1. Thoroughly clean the application surface to remove any soap scum, dust, or grease. 2. Ensure the area is completely dry, using a cloth or a hairdryer if necessary. 3. Measure the area and cut the tape to length. 4. Peel off the backing paper, position the tape, and apply light heat with a hairdryer as you press it firmly into the joint. 5. Once applied, apply firm pressure along the entire length to ensure the adhesive has bonded correctly. Avoid exposing the tape to water for at least 24 hours after application to allow the adhesive to fully set.