Drybase Tanking Slurry Kit - 12 Kg - TS-PLUS

One 12 KG kit (two 5 kg powder bags and two 1 L liquid sachets) provides enough material for two coats over approximately 5 square meters at the recommended thickness.

It is best to remove any loose or flaking paint or coatings. The surface should be sound, clean, and free from contaminants for optimal adhesion.

The pot life of the mixed slurry is approximately 30 minutes at normal temperatures. This can be reduced in warmer conditions.

The slurry typically sets in 4 to 6 hours and can be overcoated or tiled once fully cured, usually within 24-48 hours depending on conditions.

While excellent for general waterproofing, check specific product certifications if using for potable water storage. This product is not specifically certified for potable water contact.

Yes, once fully cured, tiles can be applied directly over the Drybase Tanking Slurry using a suitable cement-based tile adhesive.

Apply in temperatures between 5°C and 30°C. Avoid application in direct sunlight or during frost conditions.

Ensure accurate mixing ratios of powder to liquid polymer. Add small amounts of water only if absolutely necessary for workability, but avoid over-dilution.

Check for missed spots or insufficient coating thickness. Ensure the substrate was properly prepared and that adequate drying time between coats was allowed.

Verify that the substrate was clean, sound, and free from dust or efflorescence before application. Ensure the surface was adequately dampened (but not saturated) prior to application.

Ensure the mixing container is clean and avoid mixing larger batches than can be applied within the 30-minute pot life. Work in cooler temperatures if possible, as heat accelerates setting.