Hose Clip - 10 Pack - 80-100mm

The hose clip is made of zinc-plated steel.

This specific clip is designed for hoses with an outer diameter ranging from 80mm to 100mm.

Place the clip over the hose, slide it into position, and tighten the worm screw clockwise with a screwdriver until secure. Avoid overtightening.

These clips are generally suitable for low to medium-pressure applications. For very high-pressure systems, consult application-specific recommendations.

It means the product is manufactured in accordance with the DIN 3017 standard, a German Institute for Standardization specification for hose clamps, indicating a level of quality and performance.

Yes, they are suitable for most common hose materials like rubber and plastic. However, always check for compatibility and avoid overtightening on very soft materials.

Each pack contains 10 hose clips.

Ensure the hose diameter is within the 80-100mm range and the clip is correctly positioned over a fitting. Check if the worm screw is stripped; if so, replace the clip.

Back off the screw slightly. The external pressed threads are designed to be smooth; if damage is occurring, the hose may be too soft or brittle for this type of clamp, or overtightening has occurred.

For minor surface rust on zinc plating, clean with a soft brush. If corrosion is significant, consider replacing the clip, especially if it is in a critical application.