Polypipe Soil System 2000 - Solvent Weld - 110mm - Double Socket - Grey

Solvent weld is a process that uses a solvent cement to fuse two pieces of PVC pipe together, creating a permanent, monolithic joint.

Yes, the PVC material and secure solvent weld make it suitable for underground drainage applications.

Curing times vary depending on the specific solvent cement used and ambient temperature. Typically, initial set is within minutes, but full strength can take several hours. Always refer to the solvent cement manufacturer's instructions.

No, this is a solvent weld socket and requires solvent cement for joining. It is not compatible with push-fit systems.

The access bend allows for a change in direction while also providing an opening that can be used for inspection or rodding of the pipe system if blockages occur.

Ensure good ventilation, wear appropriate gloves and eye protection, and avoid open flames. Refer to the solvent cement's safety data sheet for full details.

Ensure surfaces were clean, dry, and properly primed/cemented. Verify sufficient curing time was allowed before system pressurization. Re-do the joint if necessary, following instructions precisely.

Check for obstructions or damage inside the socket. Ensure the pipe end is square and chamfered slightly. Re-apply primer and cement if necessary.

Ensure correct type and amount of solvent cement was used. Ambient temperature may affect curing; consult cement manufacturer's guidelines for temperature-specific application.