Best current price£5.82from City Plumbing GB
Shopping.co.uk recommended and popular offers
City Plumbing GB£5.82Visit shop Plumbright White 2 Port Manifold 22 X 10Mm Plastic Smf6741m2p
Visit shop1 offer from £5.82
View price history by clicking the chart icon.
The Plumbright 2 Port Manifold 22x10mm is designed for heating installers and DIY enthusiasts looking to split a 22mm heating feed into two 10mm lines efficiently. Its primary benefit is the significant reduction in installation time and space requirements compared to traditional tee joints, though it is specifically intended for 22mm to 10mm transitions and may not suit systems requiring different pipe diameters. This push-fit manifold combines robust engineering with a clean aesthetic, making it ideal for both concealed and visible domestic plumbing configurations.
| Model Part Number | SMF6741M2P |
|---|---|
| Brand | Plumbright |
The manifold is WRAS approved, which indicates it is suitable for use in domestic water systems; however, always check specific local regulations for your installation.
Yes, the push-fit mechanism is generally designed to be reusable, provided the internal O-rings remain undamaged during the pipe removal process.
No, the push-fit design allows for installation by hand, though a pipe cutter is recommended for achieving a perfectly square end.
The manifold is built to handle standard UK domestic heating pressures and temperatures; please refer to the technical data sheet for specific PSI/Bar limits.
Yes, this manifold is compatible with copper pipe provided the ends are prepared correctly and are free of sharp edges that could damage the seal.
Ensure the pipe is cut square and is free from scratches or burrs. Re-insert the pipe, checking that it has reached the internal stop.
Check that the release collar is not being accidentally depressed while pushing. Ensure the pipe size matches the port diameter exactly.
Verify that the pipe has been pushed fully into the fitting. If the connection continues to feel loose, inspect the O-ring for debris or damage.
Installation requires that all pipes be cut cleanly and squarely to ensure a proper seal within the push-fit mechanism. It is critical to remove any burrs or sharp edges from the pipe ends before insertion, as these can damage the internal O-rings. Ensure the pipe is fully pushed into the manifold until it seats firmly. The unit is compatible with most standard plastic and copper piping systems designed for these dimensions. No specialized grease or sealants are required for the connection, but ensure the system is pressure tested following installation to verify all seals. For maintenance, keep the area around the manifold clear of debris to prevent accidental dislodgement of the release collar.
