Actiaspet U Pins Steel Pegs - 50pcs

These pins are ideal for use with grass protection mesh and various ground cover materials like landscape fabric.

The number of pins needed will depend on the ground conditions and the material being secured. As a general guide, space the pins at regular intervals of approximately 1 meter, or closer for areas with higher winds or on slopes.

A rubber mallet or hammer is recommended. Depending on the soil conditions, a crowbar may also be useful for creating pilot holes.

Insert the pins deep enough to firmly anchor the material to the ground, typically 3/4 of the pin length. Ensure the entire curved section is buried.

Yes, the pins can be reused. However, inspect them for damage after removal and discard any bent or damaged pins.

Use a pair of pliers or a claw hammer to pull the pins out of the ground. Be careful not to damage the material.

Use a heavier mallet, pre-drill pilot holes in hard soil, or try a different angle for driving the pins.

Moisten the ground before installation or use a crowbar to make a small pilot hole.

Store pins in a dry location and clean them after each use. Consider applying a rust preventative coating.