Home Range 56mm Solvent Weld Straight Coupling - Black Plastic

This coupling is specifically designed for 56mm diameter plastic waste pipes.

You will need a pipe cutter for a clean cut, and the necessary solvent primer and solvent cement for plastic waste pipes. A measuring tape and possibly sandpaper for cleaning pipe ends are also recommended.

No, this coupling is designed for plastic waste pipe systems and is not suitable for hot water or pressure applications.

The curing time varies by solvent cement product. Always refer to the manufacturer's instructions on the solvent cement packaging. Typically, 24 hours is recommended for full joint strength before stressing the pipe.

The coupling has a black finish.

Solvent-welded joints are permanent and cannot be easily disassembled. If you need to make changes, you will need to cut out the affected section and replace it.

The plastic construction is generally suitable for outdoor use, but prolonged exposure to UV light might degrade the plastic over time. Its primary application is within building structures for waste systems.

This usually indicates insufficient or uneven application of solvent cement, or that the joint was disturbed before curing. The joint will need to be cut out and replaced.

Ensure pipes are cut to the correct length and that enough solvent cement was applied to allow for smooth insertion. The joint may need to be redone if the pipe cannot be fully seated.

Confirm that you are using a 56mm coupling with 56mm pipe. If the fit is incorrect, the coupling is likely incompatible or defective and should be replaced.