151 Stain & Damp Block - White Satin Finish - 400ml

This product is specifically designed for interior surfaces only. It is not formulated for outdoor use.

The drying time can vary based on conditions, but it typically dries quickly, often allowing for recoating or painting within an hour. Refer to the product packaging for specific drying times.

While it provides a smooth, clean finish, it is designed as a primer and sealer. For best results and a uniform appearance, it is recommended to paint over it with your desired topcoat colour.

It can be used on most common interior walls and ceilings, including plaster, drywall, and previously painted surfaces.

You must first clean the mould thoroughly with a dedicated mould remover. Ensure the area is completely dry before applying the Stain & Damp Block.

Yes, this product is effective at blocking a wide range of stains, including smoke and nicotine discolouration.

Coverage can vary depending on the surface porosity and the thickness of application. For typical stain blocking, a 400ml can should cover a moderate area; refer to the product's specific coverage guidelines if available.

Turn the can upside down and spray for a few seconds to clear the nozzle. If blockage persists, remove the nozzle and soak it in a suitable solvent, then rinse and reattach.

Ensure the can is held at the correct distance and moved in a steady, even motion during application. Apply in thin coats rather than one heavy coat. Smooth out any drips immediately if possible.

The stain may be particularly stubborn or the product may not have been applied in sufficient coats. Ensure the surface was properly prepared and apply additional thin coats until the stain is fully covered.

The surface may not have been clean, dry, or free from grease/grime. Re-clean the area thoroughly and ensure it is completely dry before reapplying.