Waste Bottle Trap - SPARES2GO

This bottle trap is designed for 1.25" or 32mm outlet pipes.

The trap features a removable bowl. Unscrew the bowl, clean it and the trap body with mild detergent and a soft cloth, then reassemble.

The 75mm water seal creates a barrier that prevents sewer gases and unpleasant odors from escaping the drain and entering your room.

Yes, it is suitable for use in standard kitchen sinks, as well as basins, bidets, and urinals.

Yes, the trap is telescopic and height adjustable, allowing for easier fitting into various plumbing setups.

The bottle trap is made from white polypropylene.

Check that all connections are securely tightened and that the rubber seals are correctly in place and undamaged. If leaks persist, you may need to replace the seals.

Ensure all slip nuts are securely tightened. Check that rubber seals or washers are correctly seated and not damaged. If necessary, replace worn seals.

Remove the bowl to check for blockages from hair, soap, or debris. Clean the trap and reinstall the bowl. If the blockage is further down the pipe, additional clearing may be required.

Confirm the water seal is sufficient. If the trap has been dry for a long time, run water to refill it. Check for any hairline cracks in the trap body or loose connections that could allow gases to escape.

This can indicate a venting issue in the plumbing system or a partial blockage. Ensure the waste pipe is properly vented and check for obstructions within the trap.