PrimaPlus Chrome Wallplate Elbow - 22mm x 3/4"Fi

PrimaPlus fittings manufactured to EN 1254 and BS standards are often suitable for gas, but always verify specific product ratings and local regulations for gas installations. WRAS approval is only for water.

The wallplate provides a decorative and supportive flange that sits flush against the wall, offering a neat finish where the pipework emerges.

This fitting is designed for copper pipes. Using it with plastic pipes may not create a secure or leak-proof seal and is not recommended unless specifically stated by the manufacturer for a particular type of plastic pipe.

You will typically need pipe cutters, a pipe reamer, and two wrenches (one to hold the fitting body, one to tighten the compression nut).

Tighten until resistance is felt, then give it an additional quarter to half turn. Avoid overtightening, which can deform the pipe or crack the olive.

With proper care and avoiding abrasive cleaners, the chrome finish is designed for durability and should last the lifetime of the fitting.

Ensure the pipe is round and free of burrs. The olive must be correctly positioned. Check if the compression nut has been adequately tightened without overtightening, which can damage the pipe or fitting.

Remove the fitting and reapply PTFE tape or thread sealant to the male thread. Ensure the male thread is clean and undamaged. Tighten the connection securely.

Verify that the pipe is the correct size (22mm) and that the end is not deformed. Ensure no internal obstruction exists within the fitting.