Best current price£4.27from Rapid Online - Rapid Electronics Ltd.
Shopping.co.uk recommended and popular offers
Rapid Online - Rapid Electronics Ltd.£4.27Visit shop Modelcraft 10347 Shaft Collar 6mm with Grub Screw Pack 10
Visit shop2 offers from £4.27 - £6.94
View price history by clicking the chart icon.
The Modelcraft Shaft Collar - 6mm is designed for machinists and DIY enthusiasts needing a reliable component to secure shafts. Its key benefit is providing a robust and easy-to-install fastening solution for 6mm diameter shafts. A potential caveat is that its primary design is for specific shaft sizes, requiring careful measurement for other applications.
| Model Part Number | 10347 |
|---|---|
| Brand | Modelcraft |
The shaft collar is made from high-grade, surface-hardened material for durability.
This shaft collar is designed to fit shafts with a 6mm diameter.
Yes, grub screws are included with each shaft collar.
Each pack contains 10 units of the Modelcraft Shaft Collar.
The outside diameter of the collar is 10mm, and its thickness is 5mm.
No, this collar is specifically designed for 6mm shafts and will not fit larger diameters.
Surface hardening provides increased durability and resistance to wear for the collar.
Ensure the grub screw is tightened sufficiently. Verify that the shaft diameter is precisely 6mm and not slightly smaller. Clean both the shaft and the inside of the collar from any grease or debris before installation.
Check if the correct size hex key is being used. If the screw head is stripped, it may need to be carefully drilled out or replaced. Contact Modelcraft for replacement parts if necessary.
Double-check that the shaft is indeed 6mm in diameter and not slightly larger. Ensure there is no burr or obstruction on the shaft preventing the collar from sliding on.
Setup: To install the Modelcraft Shaft Collar - 6mm, slide it onto the 6mm shaft. Position it where needed and then tighten the grub screw using an appropriate screwdriver (typically a hex key) until it is securely fastened. Avoid overtightening, which could damage the shaft.
Compatibility: This shaft collar is specifically designed for shafts with a 6mm diameter. Ensure your shaft matches this dimension precisely. The collar's outer diameter is 10mm and its thickness is 5mm.
Care: Keep the shaft collar clean and free from debris. For long-term storage, a light application of oil can prevent rust, especially in humid environments. Inspect the grub screw periodically to ensure it remains tight.
