B2C Brass Hosetails Barb-Bsp Male Thread Joiner Air Gas Water Fuel Hose Tails - 1.25"bspm - 25mm Barb

The hosetail is made from solid brass, which offers good durability and resistance to corrosion.

The BSP thread size is 1.25" Male.

The barb size is 25mm, designed to fit hoses with an internal diameter of approximately 25mm.

While brass is durable, the suitability for high pressure depends on the hose, hose clamp, and overall system. It's best suited for low to medium-pressure applications. Always ensure the hose and clamp are rated for the intended pressure.

It is suitable for air, gas, water, and fuel lines. Ensure the material compatibility with the specific fluid being transported.

Yes, a hose clamp is recommended to securely fasten the hose onto the barb fitting and prevent leaks or detachment under pressure.

Clean with a damp cloth. For stubborn marks, a mild soap solution can be used, followed by rinsing and drying. Avoid abrasive materials.

Ensure PTFE tape or thread sealant was applied correctly to the male BSP threads. Verify the BSP thread is clean and undamaged. Tighten the hosetail further, if possible without overtightening.

Ensure a 25mm hose is used and that it is fully seated onto the barb. Use an appropriately sized and securely tightened hose clamp. Consider a clamp designed for higher pressure if necessary.

Check for cross-threading or debris in the male BSP thread. Clean both the thread and the hosetail fitting before attempting to screw them together again.