Best current price£14.26from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£14.26Visit shop Floplast White Ogee Gutter Stopend Outlet Left Hand - 110Mm X 80Mm
Visit shop3 offers from £14.26 - £18.00
View price history by clicking the chart icon.
This guide is for homeowners and contractors installing Ogee gutter systems. It details the FloPlast Ogee Gutter Stopend Outlet (Left Hand, 110mm x 80mm, White) which provides a neat finish and secure connection at the end of a gutter run. A key benefit is its simple push-fit connection to 65mm square downpipes. However, it's crucial to note that this specific outlet is not suitable for gable ends where roof tiles overhang the fascia board; a running outlet with an external stopend is recommended in such cases.
| Brand | FloPlast |
|---|
An Ogee gutter stopend outlet is a fitting used to terminate the end of an Ogee gutter run. It seals the gutter's edge, preventing water from spilling over the side and ensuring it flows towards the downpipe.
Ogee gutters are handed. Stand facing the gutter run from the front. If the stopend outlet is on your left, you need a left-hand outlet. If it's on your right, you need a right-hand outlet.
This outlet has a direct push-fit connection for 65mm square downpipes. It can be connected to 68mm round downpipes using the separate FloPlast RDS2 adaptor.
This fitting should not be used at gable ends if the roof tiles extend past the fascia board. In such cases, a running outlet with an external stopend is required to catch water from overhanging tiles.
The dimensions are 110mm for the gutter connection and 80mm for the downpipe connection (specifically for 65mm square or 68mm round with adaptor).
Yes, it complies with BS EN 12200 / BS EN 607 standards.
Regular cleaning to remove debris is recommended. Check joints periodically for any signs of wear or leaks.
Ensure you are using the correct downpipe size (65mm square or 68mm round with adaptor). Check for any obstructions or damage on the downpipe spigot or the outlet's receiving joint. Ensure you are pushing straight and firmly.
Verify that the gutter end is clean and properly seated within the stopend outlet. If a permanent seal is required and the push-fit is not sufficient, a small amount of gutter sealant or solvent cement (specific to PVC) can be applied to the joint before assembly.
Confirm that the stopend outlet is correctly installed and fully seated. Check if the gutter is correctly sloped towards the downpipe. Ensure there are no blockages in the gutter or downpipe system.
Double-check that you have the correct Ogee gutter profile and that this is the corresponding 110mm Ogee stopend outlet. Ensure no part of the gutter edge is deformed.
Setup:
Compatibility:
Care:
