Rosfix Filtre d'aspiration 32 Mesh pour machine à peinture - TNKJ-493J
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Rosfix 32 Mesh Suction Filter is an essential maintenance component designed for professional and DIY painters using specific Graco airless spray systems. Its primary benefit is the prevention of debris intake, which ensures a consistent paint flow and protects your pump from premature wear; however, users must verify their specific pump model compatibility before purchase to ensure a proper seal.
All features
| Model Part Number | TNKJ-493J |
|---|---|
| Brand | Rosfix |
Extended Product Information
FAQs
How often should I replace the filter?
It depends on the quality of paint used, but it is recommended to replace it if you notice a decrease in pressure or visible damage to the mesh.
Can I use this with latex paint?
Yes, the 32 mesh is suitable for most standard latex paints and medium-viscosity coatings.
Is this compatible with Graco machines not listed?
No, this filter is specifically designed for the models listed (GX-21, XR series, PROX series); check your machine manual for filter specifications.
Can I clean the filter instead of replacing it?
Yes, you can rinse the filter with water or appropriate solvent, but if the mesh is frayed or clogged with hard debris, it must be replaced.
Why is it important to use a 32 mesh filter?
A 32 mesh filter balances the need to catch debris without being so fine that it restricts the flow of heavier coatings.
Troubleshooting
Pump is struggling to draw paint
Check if the filter mesh is clogged with dried paint or sediment; rinse or replace if necessary.
Paint is spitting during application
The filter may be partially blocked or air is entering the intake; check the filter seat and ensure the inlet nut is tightened correctly.
Pros and Cons
Pros
- Prevents costly pump damage from debris
- Easy and fast to install without special tools
- Ensures consistent finish quality
- Compatible with a wide range of popular Graco models
Cons
- Must be matched specifically to 32 mesh requirements
- Requires regular inspection to maintain flow rates
- Not compatible with all Graco pump series
Setup, Compatibility & Care
To install, ensure the sprayer is turned off and depressurized. Unscrew the intake housing, remove the old filter, and seat the Rosfix filter firmly into the suction tube. This filter is specifically engineered for compatibility with the following Graco models: GX-21, XR5, XR7, XR9, SR7, PROX7, and PROX9. For care, always clean the filter immediately after each use. If the mesh shows signs of deformation or tearing, replace it immediately to prevent damaging the internal pump seals.