Eagle Rock Speaker - 4 inch - Grey

For larger areas, it is recommended to use multiple Eagle Rock Speakers to ensure adequate sound coverage and stereo imaging. One unit is best suited for a patio or a defined seating area.

You will need a low-impedance amplifier that is rated for an 8 Ohm speaker load. Please consult your amplifier's manual for specific compatibility.

While designed to blend into landscaping, it is recommended to place the speaker on the surface or slightly covered with foliage rather than burying it completely to ensure optimal sound projection and prevent damage.

You can connect multiple 8 Ohm speakers to a compatible amplifier. The method depends on your amplifier's capabilities (e.g., series or parallel wiring), so consult your amplifier's manual for instructions on connecting multiple speakers to maintain the correct impedance.

No, this is a passive speaker and receives its power directly from your connected amplifier via speaker wire.

Please refer to the product packaging or the retailer's information for specific warranty details, as warranty terms can vary.

Verify the amplifier is powered on and set to an 8 Ohm output. Check that speaker wire connections are secure at both the speaker and amplifier terminals. Ensure correct polarity (+ to +, - to -) is maintained.

Ensure the amplifier volume is not set too high. Check that the speaker wire gauge is appropriate for the length of the run and the amplifier's power output. Inspect the speaker grille for obstructions.

Ensure the speaker is intended for outdoor use and is rated for the conditions it was exposed to. Allow the speaker to dry completely before attempting to use it again. Check connections for corrosion if the issue persists.