IG Lintels L1/S100 Standard Structural Steel Lintel - 900mm

The perforations provide a key for plaster, allowing for a better bond and finish.

A minimum end bearing of 150mm on each side of the opening is required.

These lintels are suitable for cavity widths between 95-110mm.

These lintels are designed for standard load-bearing applications in cavity walls.

Follow standard building practices for lintel installation and ensure the lintel is level and properly supported, with the required end bearing.

These lintels are suitable for a wide range of buildings but are specifically designed for standard load-bearing applications within the specified cavity width range.

If the lintel is damaged, assess the extent of the damage. For minor damage, touch up the protective coating. For significant damage, consider replacing the lintel or consulting a structural engineer.

Check the end bearing to ensure it meets the minimum requirement of 150mm on each side. If the bearing is insufficient, the lintel may not be adequately supported. Check for any damage or stress on the lintel.

Ensure the opening is accurately measured and prepared before installing the lintel. Use appropriate shims and supports to level the lintel during the installation process.

Inspect the protective coating for any damage. Address any areas where the coating is compromised and apply a suitable anti-corrosion treatment or coating if necessary.