Grayston Carbon Effect Starter Switch Panel - 3 Accessory Switches

Each switch on the Grayston panel is rated for a maximum of 30 amps.

No, the panel itself does not include integrated fuses. It is recommended to install appropriate fuses or circuit breakers at the power source for each circuit controlled by the panel.

For accessories drawing more than 30 amps, you must use an external relay. The switch on the panel will then control the relay, which in turn powers the high-draw accessory.

The dimensions of the Grayston Carbon Effect Starter Switch Panel are 135mm in length and 60mm in width.

While the panel is robust, it is primarily designed for motorsport enthusiasts and custom applications. Installation requires electrical knowledge, and it lacks features like illumination found in many street-vehicle switch panels.

Please refer to the warranty information provided by the retailer or Grayston for specific warranty details.

The panel operates on a standard 12-volt DC electrical system. The wiring harness connects to the vehicle's 12V power supply.

Verify the 12V power supply to the panel. Check all wiring connections to the switch and the accessory. Ensure the accessory itself is functional and within the 30A rating of the switch. If using high-draw accessories, ensure an external relay is correctly wired.

Confirm the starter button is wired correctly to the starter solenoid circuit. Check the 12V power supply to the button. Ensure the engine has sufficient power and is in neutral/park if applicable.

Immediately disconnect power. Check for short circuits in the wiring. Ensure the accessory's amperage draw does not exceed the switch's 30A rating. If exceeding 30A, an external relay must be used.

Gently check for obstructions. Ensure the switch is mounted correctly and not under stress. If damaged, the switch may need replacement.