Hycote Yellow Fast Drying Aerosol Spray Paint - 400ml

This paint is suitable for a wide range of surfaces including metal, plastic, wood, ceramics, and is compatible with cellulosic and acrylic vehicle paintwork when used with appropriate primers.

While the paint can be used on many surfaces, using a Hycote primer is highly recommended for optimal adhesion, durability, and finish, especially on plastics and metal.

Thanks to its compressed consol technology, one 400ml can offers up to double the coverage of conventional spray paint cans. Coverage will vary depending on the surface and application thickness, but typically a 400ml can covers approximately 1.5 to 2 square meters.

The paint is fast drying. It typically has a dust-free time of around 10-15 minutes and can be recoated after 1-2 hours, depending on temperature and humidity.

After painting, turn the can upside down and spray for a few seconds to clear the nozzle. If it becomes blocked, you can try removing and cleaning the nozzle with a solvent like white spirit.

Yes, but adequate ventilation is crucial. Ensure the area is well-aired and consider using a mask and protective sheeting to prevent overspray.

When stored correctly in a cool, dry place, the spray paint generally has a shelf life of several years. Always check the batch date on the can.

Ensure the can is adequately shaken. Hold the can upright and at a consistent distance from the surface. If the nozzle is blocked, clean it with a solvent or replace the can.

The surface may not have been properly prepared (clean, dry, free from grease). Ensure a suitable primer was used, especially on plastic or metal surfaces. Re-sand and reapply primer if necessary.

The paint was applied too thickly or from too close a distance. Apply paint in thin, even coats. Allow each coat to flash off before applying the next. If runs occur, let them dry, then lightly sand and reapply.

The nozzle may be blocked. Turn the can upside down and spray for a few seconds to clear any residual paint from the nozzle. If the blockage persists, carefully remove and clean the nozzle with a solvent.