10X Grey Rj45 Strain Relief Network Cable Cat5/6 Connector Boot Cover Cap End - Loops

These boots are specifically designed for CAT5e and CAT6 network cables.

While they might fit some thicker cables, they are optimized for CAT5e/CAT6 and cables with an outer diameter up to 6.5mm. Larger cables may not fit or provide a secure seal.

Each pack contains ten (10) Grey RJ45 strain relief boots.

Their primary functions are to protect the RJ45 connector's release tab from breaking and to provide strain relief to the cable, preventing damage at the termination point.

No, the boots must be slid onto the cable *before* the RJ45 connector is crimped.

Strain relief means the boot helps absorb bending stress at the connector end of the cable, preventing the internal wires or the connection point from being damaged when the cable is bent or pulled.

While they can be removed and re-slid, they are intended for permanent installation after the connector is crimped. Repeated removal may cause them to loosen or become damaged.

Ensure you are using a compatible cable (CAT5e/CAT6) and that the cable's outer diameter does not exceed 6.5mm. If the cable is stiff, gently twisting it might help.

Ensure the RJ45 connector is properly seated and crimped. The boot is designed to slide up to the base of the connector; if the connector is not fully attached, there may be a gap.

Double-check the crimping process. The boot provides strain relief, but the integrity of the connection relies on proper crimping. Ensure all wires are correctly terminated inside the RJ45 connector.