Best current price£20.99from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£20.99Visit shop Liberon 003866 Beeswax Liquid Antique Pine 500Ml 3282390003473
Visit shop
B&Q£21.15Visit shop B&Q - 003866 Beeswax Liquid Antique Pine 500Ml Libblap500
Visit shop5 offers from £20.99 - £32.67
View price history by clicking the chart icon.
Liberon Beeswax Liquid in Antique Pine is designed for woodworkers and DIY enthusiasts looking to nourish and protect absorbent woods like pine and oak, especially unsealed surfaces. Its key benefit is providing deep nourishment, protecting against dryness, and imparting an authentic finish to large, dry areas such as beams, floors, doors, and staircases. A caveat to note is its unsuitability for high-moisture areas like kitchens and bathrooms.
| Model Part Number | 003866 |
|---|---|
| Brand | Liberon |
It is ideal for absorbent woods such as pine and oak, especially unsealed surfaces. It is suitable for both hard and soft woods.
No, it is not suitable for high-moisture areas like kitchens and bathrooms due to its protective properties not being water-resistant.
Ensure the wood surface is clean, dry, and free from dust. For best results, use on unsealed wood.
This certification means the product meets safety standards for toys, indicating it has low toxicity.
Store in a cool, dry place away from direct sunlight. Be aware that it may thicken in cold weather.
Reapplication frequency depends on the item's use and environment. Typically, reapplication is needed when the finish begins to dull or show signs of wear.
It is primarily designed for unsealed woods. Applying over existing finishes may result in poor adhesion and an inconsistent appearance. Always test in an inconspicuous area first.
Stand the container in a bowl of hot water for 5 minutes to soften the wax before use.
Ensure the wax is applied thinly and evenly. Buff off all excess thoroughly with a clean cloth. Apply a second thin coat if needed after the first has dried.
The wood may be highly absorbent. Apply a second, thin coat of wax, allowing for better penetration. Ensure the surface was properly prepared and free of sealants.
Too much wax was applied, or not enough was buffed off. Use a clean cloth with a little solvent (as recommended by manufacturer for wax removal) to gently lift sticky areas, then re-buff.
Setup: Ensure the wood surface is clean, dry, and free from dust or old finishes. If the product has thickened due to cold weather, stand the container in a bowl of hot water for approximately 5 minutes until it softens.
Application: Apply Liberon Beeswax Liquid thinly and evenly using a clean, lint-free cloth or a brush. Work in the direction of the wood grain. Allow it to penetrate the wood for a few minutes, then buff off any excess with a clean cloth. For a higher sheen, apply a second thin coat after the first has dried and buff again.
Compatibility: This product is suitable for use on most absorbent, unsealed hard and soft woods. It is not recommended for high-moisture areas such as kitchens and bathrooms. Test on an inconspicuous area first to ensure desired results.
Care: Regular dusting with a soft cloth is recommended. For cleaning, use a slightly damp cloth and dry immediately. Avoid harsh chemical cleaners. Reapplication may be needed periodically, depending on use and environmental conditions.
