Best current price£34.98from eBay
Shopping.co.uk recommended and popular offers
eBay£34.98Visit shop Husqvarna Cylinder & Piston Assembly Fits 350 351 353 346XP Chainsaw
Visit shop1 offer from £34.98
View price history by clicking the chart icon.
The RocwooD 44mm Cylinder & Piston Assembly (MPN 72855) is designed for professional landscapers and homeowners looking to restore performance to their Husqvarna 350, 351, 353, or 346XP chainsaws. This comprehensive kit provides a reliable aftermarket alternative to original equipment, helping you regain full engine compression and cutting power. Please note that as a non-genuine part, it requires careful verification of your current piston diameter to ensure a proper fit before installation.
| Model Part Number | 72855 |
|---|---|
| Brand | RocwooD |
No, this is a high-quality aftermarket replacement part manufactured by RocwooD.
No, the kit includes the cylinder, piston, rings, gudgeon pin, and circlips only.
Do not install this kit. If your chainsaw has a different bore size, this assembly will not function correctly and may damage the engine.
It is recommended to purchase a new base gasket separately, as one may not be included in all kit configurations.
No, this kit is specifically designed for models with a 44mm bore like the 350, 351, 353, and 346XP.
Ensure the rings are properly seated in the piston grooves and the cylinder bolts are torqued to the manufacturer's specification.
Check that the spark plug is seated correctly and verify that the cylinder base gasket is creating an airtight seal.
To install this assembly, you must remove the starter housing, top cover, carburetor, and the old cylinder block. It is highly recommended to replace the base gasket and crankshaft seals simultaneously to ensure no air leaks occur during operation.
This kit fits the following Husqvarna models:
Warning: Always verify your current piston diameter is 44mm before ordering, as some variants of these saws may use different bore sizes depending on the production year.
After installation, use a high-quality 50:1 fuel-to-oil mix. Avoid running the saw at full throttle for extended periods during the first two tanks of fuel to allow the rings to properly seat against the cylinder wall.
