JORDAN&JUDY No-drill Pegboard Organizer - 30x30cm Square Board Set
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The JORDAN&JUDY No-drill Pegboard Organizer is an ideal solution for renters, homeowners, and office workers looking to maximize vertical storage without damaging their walls. This versatile 30x30cm kit provides an all-in-one system for decluttering desks, kitchens, and craft rooms using a robust, tool-free adhesive installation. While the adhesive mounting system offers convenience and damage-free setup, it is limited to smooth, non-porous surfaces, making it unsuitable for heavily textured walls or wallpaper.
All features
| Brand | JORDAN&JUDY |
|---|
Extended Product Information
FAQs
Can I install this on a brick wall?
No, the adhesive requires a smooth, non-porous surface. It will not bond effectively to brick, concrete, or raw wood.
What is the maximum weight the pegboard can support?
While the adhesive is strong, we recommend keeping the total load under 2kg to ensure the longevity of the wall bond.
Can I remove the board and move it to a different location?
The adhesive is intended for permanent installation. Removing it will likely damage the adhesive strip, and it cannot be reused without applying new double-sided mounting tape.
Are additional accessories compatible with this board?
The board uses standard peg spacing, but for the best fit, it is recommended to use JORDAN&JUDY brand accessories designed for this specific pegboard.
Will this work in a high-humidity environment like a bathroom?
Yes, provided the surface is clean, smooth, and non-porous tile or glass. Ensure the area is wiped dry before installation.
Troubleshooting
Board is pulling away from the wall.
Ensure the surface was completely clean and dry before application. If it persists, the surface may be too textured or dusty for the adhesive to bond.
Accessories are not clicking into place.
Ensure the hooks and shelf tabs are properly aligned with the pegboard holes. Apply a slight downward pressure to 'lock' the accessory into the slot.
Adhesive residue left on the wall after removal.
Gently heat the adhesive with a hairdryer to soften it, then use a gentle citrus-based adhesive remover to wipe away the remaining residue.
Pros and Cons
Pros
- Tool-free, damage-free wall installation
- Comprehensive kit includes variety of storage accessories
- Modular design allows for custom accessory arrangement
- Compact 30x30cm footprint fits in tight spaces
- Ideal for rentals or temporary home office setups
Cons
- Not compatible with heavily textured, uneven, or dusty walls
- Adhesive may be difficult to remove if applied to delicate surfaces
- Fixed dimensions may not suit large-scale storage requirements
- Maximum weight capacity is limited compared to screw-in pegboards
Setup, Compatibility & Care
Setup Instructions:
- Clean the target surface thoroughly with alcohol or soap and water to ensure it is free of dust and grease.
- Allow the surface to dry completely.
- Peel the protective backing from the adhesive strips on the rear of the board.
- Align the board carefully on the wall and press firmly for 30 seconds to ensure a secure bond.
- Wait at least 24 hours before adding accessories or items to allow the adhesive to reach maximum strength.
Surface Compatibility:
Use only on smooth, clean surfaces. Avoid porous materials such as brick, concrete, or fibrous wallpaper, as the adhesive will not hold properly.
Care and Maintenance:
Wipe the pegboard and accessories with a soft, damp cloth. Do not use abrasive cleaners, as these may scratch the finish of the plastic components.