Infinity Wax Tyre Coat Dressing 5L - Satin Finish, SiO2 Infused

The hydrophobic protection can last up to four weeks, depending on environmental conditions, mileage, and driving habits.

No, this product is formulated for exterior use on tyres, rubber seals, and unpainted plastics. Do not use on interior surfaces.

It's best to spray the product onto an applicator pad or microfiber cloth and then wipe it onto the trim for controlled application and to avoid overspray.

No, the water-based formula is designed to dry to a natural satin finish with minimal to no greasy residue, and it dries quickly.

Rinse applicator pads and brushes thoroughly with water after each use to remove product residue and maintain their condition.

The product is water-based, which generally makes it more environmentally friendly than solvent-based alternatives. Always dispose of any waste materials responsibly.

Reapplication frequency depends on desired appearance and protection levels, but typically every 2-4 weeks to maintain the satin finish and hydrophobic properties.

Ensure the product was spread evenly with an applicator. Reapply lightly and ensure full coverage.

Allow a longer cure time before driving. Ensure no excess product was left on the tyre sidewall; wipe off any drips.

Ensure the surface is clean and dry. For heavily faded trim, a second light coat might be needed after the first has cured.

This can occur if too much product is applied or if the surface is not completely dry. Wipe down with a clean microfiber to 'de-gloss' if needed.