Ryobi R18PD3-215GZ 18 V ONE+ Cordless Combi Drill Starter Kit - 1.5 Ah

This drill is compatible with standard drilling and screwdriving bits up to 13mm.

There is a switch on top of the drill, typically marked '1' and '2'. Select the speed that best suits your current task.

There's a collar near the chuck with numbered settings. Choose a setting appropriate for the material and screw size. For driving screws, start with a low setting and increase it until the screw is flush without stripping.

Warranty information is available from the manufacturer. Refer to the product documentation or contact Ryobi customer service.

Yes, this drill is compatible with all Ryobi ONE+ batteries.

Keep the drill clean, store it properly, and inspect it regularly for any signs of damage. Make sure to charge batteries before use and store them properly.

If the drill overheats, stop using it immediately and let it cool down. Overheating may be caused by excessive use or using the incorrect setting. Also, check the air vents for blockages.

Check if the battery is properly inserted and charged. Ensure the power switch is in the 'on' position.

Tighten the chuck securely around the bit. Ensure the bit is the correct size and type for the task.

Ensure the battery is fully charged. Reduce the speed or torque settings for the current task. Consider using a different drill bit if it's too dull for the material.