Best current price£6.64from Bradfords
Shopping.co.uk recommended and popular offers
Bradfords£6.64Visit shop Polypipe WS56W 50mm Swept Tee 92.5 Degree Waste Pipe Fitting Solvent Weld ABS White
Visit shop1 offer from £6.64
View price history by clicking the chart icon.
The Polypipe WS56W Swept Tee is designed for plumbers and DIY enthusiasts needing a reliable component for residential waste drainage systems. Its key benefit is providing efficient directional flow at a 92.5-degree angle, ensuring smooth waste transport from sanitaryware and kitchen appliances. A potential caveat to consider is that it requires solvent welding for installation, which needs specific tools and adherence to safety guidelines for a secure, leak-free joint. This 50mm ABS swept tee offers robust performance and integrates seamlessly with other Polypipe waste system components.
| Model Part Number | WS56W |
|---|---|
| Brand | Polypipe |
A swept tee is used in plumbing to create a smooth, gradual change in direction of flow, typically at a 92.5-degree angle, to efficiently guide waste water from one pipe to another while minimizing the risk of blockages.
No, this is an ABS fitting designed for ABS pipe systems using ABS solvent cement. While it might physically fit into a PVC pipe, the solvent welding process and material compatibility require ABS for both pipe and fitting.
ABS pipes and fittings are joined using a two-step process: applying an ABS primer to clean and soften the surfaces, followed by an ABS solvent cement to fuse the parts together. Ensure proper ventilation and allow sufficient curing time.
ABS is generally suitable for moderate hot water temperatures found in residential appliances. However, for extreme or continuous high temperatures, other materials like cast iron or specific plastics might be recommended. Consult local plumbing codes for specific applications.
Curing times vary based on temperature, humidity, and the specific solvent cement used. Typically, joints should not be disturbed for at least 30 seconds after joining, and full strength is usually achieved after 24 hours. Always refer to the solvent cement manufacturer's instructions.
'50mm' refers to the nominal diameter of the pipe that fits into the fitting's sockets. '92.5 degrees' indicates the angle of the directional change the tee provides.
Ensure surfaces were properly cleaned and primed/cemented. Check for adequate curing time. If leakage persists, the joint may need to be cut out and redone.
Ensure the pipe end is correctly chamfered and that no excess cement or debris is inside the fitting socket. Reapply primer and cement if necessary.
Verify that the 92.5-degree angle is not causing an unintended trap or restriction. Check for any debris lodged in the pipework during installation.
Setup: Installation requires the use of ABS solvent cement and primer. Ensure both surfaces to be joined are clean, dry, and free from grease. Apply primer to both surfaces, followed by an even coat of solvent cement to both. Immediately push the fitting and pipe together with a slight twisting motion until fully seated. Hold in place for 30 seconds to prevent slippage. Allow adequate curing time as per the solvent cement manufacturer's instructions before use (typically 24 hours for full strength).
Compatibility: The WS56W is designed to connect with other 50mm ABS pipes and fittings using solvent weld joints. It is part of the Polypipe Solvent Weld Waste System and is compatible with their range of traps, connectors, and waste outlets. Always ensure you are using ABS-specific solvent cement and primer.
Care: The ABS material is low maintenance. Clean the exterior with a damp cloth if necessary. Avoid using abrasive cleaners or solvents that could damage the plastic. Ensure the waste system connected to this tee is regularly flushed to prevent internal buildup.
