As Creation Yellow Diggers Wallpaper Border - 35871-2

Use a standard wallpaper paste suitable for non-woven or paste-the-wall products. Always follow the adhesive manufacturer's instructions for application and drying times.

It is best applied to a clean, bare wall. Applying over existing wallpaper may lead to adhesion issues or an uneven finish. Remove old wallpaper first.

Most wallpaper borders can be removed by starting at a seam and peeling slowly. If adhesive residue remains, use a wallpaper stripper solution or warm, soapy water and a sponge.

The product description specifies the pattern repeat is 53 cm. Specific width and length of the roll are not provided but are typical for wallpaper borders.

This border is designed for general interior walls. It is not recommended for high-moisture areas like bathrooms or kitchens unless specifically stated by the manufacturer, as excessive humidity can affect adhesion and durability.

Measure the total length of the walls where you want to apply the border. Divide this total length by the pattern repeat (53 cm) to estimate the number of pattern repeats needed, and add a little extra for cuts and errors.

Gently lift the edge of the border and reapply, smoothing from the center outwards with a clean, dry cloth or a plastic smoother.

Carefully peel back the section and adjust the positioning. Ensure the 53 cm repeat is correctly matched with the previous section before pressing firmly.

Check that the correct type of wallpaper adhesive was used and applied evenly to the wall. Ensure the wall surface was properly prepared (clean, dry, and smooth).

This is unlikely if all strips are from the same production batch. If perceived, ensure lighting conditions are consistent and that the pattern is aligned correctly.