Shower Seal - 800mm Length - Fits 8-10mm Glass

This seal is designed to fit glass panels that are 8mm, 9mm, or 10mm thick.

No, the rigid PVC U-section is designed to grip the glass securely without the need for any additional adhesive.

No, this seal is specifically designed for straight glass edges only and will not conform to curved surfaces.

The soft, flexible bubble at the bottom of the seal is designed to effectively seal gaps ranging from 2mm to 7mm.

You can cut the seal to size using a sharp utility knife or a fine-toothed saw. Ensure the cut is clean and straight for a proper fit.

Yes, this seal can be used vertically on the upright edge of a glass panel to create a seal between the glass and a wall or tile.

Clean the seal periodically with a damp cloth and mild soap. Avoid abrasive cleaners, as they can damage the material.

Ensure the glass edge is clean and free of debris. Try warming the seal slightly with a hairdryer on a low setting to make it more pliable. Ensure you are pushing the U-section onto the glass, not trying to slide it.

Check that the seal is fully seated on the glass edge and that the flexible bubble is making firm contact with the shower tray or bath. Ensure the gap being sealed is within the 2mm-7mm range specified. If the seal was slid onto the glass during installation, it may have been stretched or damaged; consider replacing it.

This usually indicates the glass thickness is outside the 8-10mm range or the seal was not fully pushed on. Ensure the correct glass thickness is used and re-seat the seal firmly from the bottom up.

This product is designed for straight runs. If your shower screen has curved corners or junctions, this seal may not be suitable. Consider an alternative seal designed for corner applications or check if the seal needs to be cut and joined precisely at corners.