Setup, Compatibility & Care
Before installation, ensure the engine is off and all electrical consumers are switched off. Because this is an AGM battery, it is critical to confirm that your vehicle's Battery Management System (BMS) is set to "AGM" mode during registration to ensure the alternator provides the correct charging voltage.
- Measure your existing battery tray to ensure it accommodates the 278mm x 175mm x 190mm dimensions.
- Verify the terminal layout; this unit has the positive pole at the front right.
- Clean the battery cables and terminals of any corrosion before securing the new battery.
- Tighten the battery hold-down clamp securely to prevent vibration damage.
- If your vehicle requires diagnostic battery registration, ensure this is performed after installation to calibrate the charging sensor.