Best current price£36.49from eBay
Shopping.co.uk recommended and popular offers
eBay£36.49Visit shop HOTPOINT Tumble Dryer Heating Heater Element Thermostat TCFS73BGPUK TCFS93BGPUK
Visit shop2 offers from £36.49 - £37.79
View price history by clicking the chart icon.
This genuine Hotpoint 2050w replacement heating element is designed for DIY enthusiasts and homeowners looking to restore their tumble dryer's performance without the cost of a new appliance. It effectively resolves issues where the machine runs but fails to produce warm air, though installation requires basic technical knowledge and proper safety precautions to ensure a successful repair.
| Model Part Number | TCFS73BGPUK |
|---|---|
| Brand | Hotpoint |
If the drum rotates but the air inside remains cold, the heating element is the most likely component to have failed.
Yes, this is an original manufacturer replacement part (MPN: C00506093) designed specifically for Hotpoint appliances.
You typically need a standard screwdriver set and a pair of pliers to remove the spade connectors, though a socket set can make opening the cabinet panels easier.
It is highly recommended to check or replace the thermostats alongside the heating element, as a faulty thermostat is often the root cause of an element burning out.
No, this part is designed specifically for Hotpoint dryers. Using it in incompatible models may cause damage or safety hazards.
Check the thermal cut-out stat or the thermostats associated with the heater assembly for continuity, as these may have blown due to the original heater failure.
Ensure all wire connections are tight and that no terminal is touching the metal casing of the dryer, which would cause a short circuit.
Before beginning, ensure the dryer is completely disconnected from the power supply. Consult your specific Hotpoint user manual or check the data plate on the door rim to confirm the MPN C00506093 is compatible with your appliance. Installation typically involves removing the rear or side panel to access the heating assembly; take clear photos of the wiring before disconnecting terminals to ensure correct reassembly. To maintain the new element, always clean the lint filter after every use and ensure the dryer vents are free from blockages, as restricted airflow is the primary cause of premature element failure.
