Water Underfloor Heating Kit - 7 Port Manifold

This manifold supports a maximum of 7 heating zones.

No, this kit includes the manifold, pump, and blending valve set. Underfloor heating pipes, actuators, and thermostats need to be purchased separately.

The manifold comes pre-mounted with a pump and blending valve for easier installation. However, basic plumbing knowledge is recommended. If you are unsure, it is best to consult a qualified heating engineer.

The manifold is designed to be configured for either left or right-hand supply. Refer to the installation manual for specific instructions on how to adjust the configuration.

The manifold includes a high-quality, energy-efficient pump designed for central heating systems.

The blending valve mixes hot water from the primary heating circuit with cooler return water to achieve the desired lower temperature required for underfloor heating, protecting the system and ensuring comfort.

Check if the corresponding actuator is open and if the zone thermostat is calling for heat. Ensure the zone pipework is not blocked.

Verify the main system pressure. Check for any leaks in the manifold connections or pipework. Ensure the pump is functioning correctly.

Air trapped in the system can cause noise. Bleed the air from the manifold and system. Ensure the pump speed is set appropriately.

Ensure each zone has its own thermostat and actuator correctly installed and configured. Verify that the blending valve is set to the desired water temperature.