Tycner Waste Pipe Reducer - 50X40mm

Its main purpose is to connect a larger 50mm outer diameter waste pipe to a smaller 32mm outer diameter drain pipe, creating a secure and watertight joint.

No, it features a push-fit design and requires no special tools for installation. It is designed for quick, tool-free application.

It is designed for use with standard 50mm OD waste pipes and 32mm OD drain pipes or fittings, commonly found in household plumbing for sinks, baths, and appliances.

It is ideal for standard gravity-fed waste water systems. It is not designed for high-pressure applications.

Ensure that the ends of both pipes are clean, dry, and free from damage. Push the reducer firmly and evenly onto both pipes until fully seated. The flexible rubber creates the seal.

The reducer connects a 50mm outer diameter pipe to a 32mm outer diameter pipe.

While it can be used inside the boss shoulders of junctions, it is a rubber push-fit connector and not designed for solvent welding.

Ensure both pipe ends are clean and dry. Verify that the reducer is fully and evenly pushed onto both pipes. Check for any damage to the rubber seal.

Ensure you are using the correct end for each pipe size (50mm end for 50mm pipe, 32mm end for 32mm pipe). Lightly moisten the pipe ends or the inside of the reducer with water or a mild soap solution to aid insertion. Ensure there are no obstructions.

The reducer may not be fully seated. Remove and re-apply firm, even pressure to ensure it is pushed all the way onto both pipes. Check that the pipes themselves are rigid and not collapsing.