LA-CO Flux Paste - 125G - Brush in Cap

LA-CO Flux Paste is used to prepare metal surfaces for soldering, particularly in plumbing and metalworking. It cleans and promotes solder flow.

Yes, LA-CO Flux Paste is non-toxic and free of lead and zinc chloride. However, always use it in a well-ventilated area.

It is suitable for use with copper, brass, galvanized iron, lead, zinc, tin, silver, nickel, mild steel, terne plate (tin-plated iron or steel), and malleable iron.

Apply a thin, even coat of flux to the surfaces of the metal joints before soldering, using the brush in the cap.

Yes, it's recommended to clean the joint with a damp cloth or wire brush after soldering to remove any flux residue.

WRAS (Water Regulations Advisory Scheme) approval means the product meets the necessary standards for use in water installations.

Store the flux in a cool, dry place with the cap tightly closed to prevent it from drying out.

Ensure the joint is clean and prepped, and apply sufficient heat to the metal. Make sure to apply a sufficient amount of flux.

Ensure the joint is properly heated and that the solder has flowed completely around the fitting. Re-solder the joint if needed.

Wipe away excess flux with a damp cloth or wire brush after soldering. For more stubborn residue, use a suitable solvent (check metal compatibility).