All Balls Wheel Bearing Kit Rear - All Years

The kit includes all the necessary bearings and seals required to re-fit a wheel, specifically for the rear wheel of the Sur-Ron X Light Bee.

Wheel bearings typically fail due to contamination from water and dirt, which erodes the bearing's internal components and lubricant.

The bearings feature low drag, double lip rubber seals designed to provide superior exclusion of water and dirt, along with improved grease retention.

This specific kit is designed for the Sur-Ron X Light Bee model for all years. Compatibility with other models is not guaranteed.

Installation requires mechanical knowledge and appropriate tools to press out old bearings and press in new ones. It is recommended to consult a service manual or a professional mechanic if you are unsure.

Replacement frequency depends on riding conditions. Inspect bearings periodically, especially after exposure to water, mud, or significant dust. Replace them if you notice any play, noise, or stiffness.

Ensure the bearing was pressed in straight and square. Over-pressing or uneven force can damage the bearing. Check for any debris trapped during installation.

The seal was likely not fully seated or was forced in at an angle. Remove the wheel, carefully re-seat the seal, ensuring it's flush with the hub surface.

This could indicate debris within the bearing or a damaged bearing from installation. Double-check the bearing for damage and ensure the seal is properly installed to prevent contamination.

Verify that all axle nuts and related components are tightened to the correct torque specifications. The issue may not be with the bearings themselves but with their installation or surrounding components.