Setup, Compatibility & Care
Installation Steps
- Power Off: Always isolate the appliance from the mains power supply before starting.
- Access the Back: Remove the rear internal panel of the oven, usually held in place by a few screws.
- Disconnect Wires: Note the position of the wire connectors before removing them from the old element terminals.
- Replace: Unscrew the faulty element, insert the new Beko part, and reconnect the power cables.
- Test: Secure the panels and turn on the power to test the element at a low temperature setting.
Compatibility
This part is compatible with a wide range of Beko models, including the BD634S, ODF21300B, and OIF22300X series. Always verify the MPN (262900074) matches your oven's data plate.