Best current price£45.00from Homebase
Shopping.co.uk recommended and popular offers
Homebase£45.00Visit shop D-C-Fix Nordic Elm Light Grey Sticky Back Plastic Vinyl Wrap Film 67.5Cm X 10M
Visit shop3 offers from £45.00
View price history by clicking the chart icon.
This d-c-fix Nordic Elm Light Grey Vinyl Film is ideal for DIY enthusiasts and renters looking to refresh home surfaces like kitchen doors, worktops, and furniture. Its key benefit is an easy, cost-effective way to achieve an authentic woodgrain look, with the caveat that proper sealing around wet areas is crucial for longevity. This German-manufactured, self-adhesive film is repositionable, wipe-clean, and heat-resistant up to 70°C, offering a practical and stylish update.
| Model Part Number | 67.5cm x 10m |
|---|---|
| Brand | d-c-fix |
Yes, it can be used on kitchen worktops, but it's essential to use heat mats for hot pans and coasters for drinks, and to seal edges around wet areas with silicone for best longevity and to prevent moisture damage.
Clean with a soft, damp cloth. For tougher marks, use a mild soap solution and wipe clean. Avoid abrasive cleaners or scouring pads.
For best results and adhesion, the surface should be smooth and clean. While it might adhere to very mild textures, significant texture will likely prevent a smooth finish and compromise the bond.
Apply the film slowly and steadily, peeling back only a small portion of the backing at a time. Use a squeegee or a firm cloth to smooth the film from the center outwards as you apply it.
The adhesive is designed for reliable adhesion but is also removable. For areas subject to significant wear or moisture, proper application and sealing are key to long-term performance.
The film is repositionable. If you make a mistake, simply peel it back carefully and reapply. Ensure the surface remains clean during this process.
While the film is durable, prolonged direct sunlight can cause fading or degradation over time. It is best to avoid constant, intense sun exposure if possible.
Gently lift the edge of the film near the bubble and use a pin to prick the bubble. Then, smooth the film down firmly with a squeegee or cloth.
Ensure the surface is clean, dry, and smooth. Re-apply gentle heat with a hairdryer (do not overheat) to activate the adhesive, then press firmly. Check that the backing paper has been fully removed.
Use a sharp craft knife or scissors and a ruler on a cutting mat for precise cuts. The grid on the backing paper can assist with alignment.
Ensure edges are clean and dry. Apply a bead of silicone sealant along the edge, especially in wet areas, to create a waterproof seal.
Gently lift the affected area, re-smooth the film with light heat from a hairdryer if needed, and carefully reapply, working out any creases.
Setup: Ensure the surface you intend to cover is clean, dry, and smooth. Remove any dust, grease, or old adhesive. Carefully peel back a small section of the backing paper and align the film. Gradually peel and smooth the film onto the surface using a squeegee or a soft cloth, working from the center outwards to avoid air bubbles. If you need to reposition, gently peel the film back and reapply.
Compatibility: This film is best suited for smooth, non-porous surfaces such as sealed wood, laminate, metal, glass, and painted walls. It is not recommended for textured, unsealed, or very rough surfaces, as this will compromise adhesion and finish.
Care: Clean the film regularly with a damp cloth and mild soap if necessary. Avoid abrasive cleaners or scrubbing pads, as they can scratch the surface. For prolonged use, especially in kitchen or bathroom environments, ensure all edges around wet areas (sinks, hobs) are properly sealed with silicone to prevent moisture from seeping underneath.
