Best current price£240.00from eBay
Shopping.co.uk recommended and popular offers
eBay£240.00Visit shop Death By Audio Dream Station Stereo Reverb and Delay Effects Pedal (NEW)
Visit shop2 offers from £240.00 - £248.77
View price history by clicking the chart icon.
The Death By Audio Dream Station is designed for guitarists and electronic musicians seeking to integrate versatile reverb and delay effects into their signal chain. Its key benefit is the ability to craft a wide spectrum of atmospheric and echo-laden sounds within a single, user-friendly pedal. A potential caveat for some users might be the learning curve involved in mastering its full creative potential, especially the feedback control.
| Model Part Number | DBA-DST |
|---|---|
| Brand | Death By Audio |
While primarily designed for instrument-level signals, you might be able to use it with a microphone if you have a preamp that can boost the microphone signal to line level before it reaches the Dream Station.
The 'Bright' setting emphasizes higher frequencies for a more transparent sound, 'Full' provides a balanced, natural tone, and 'Dark' rolls off high frequencies for a warmer, more subdued effect.
Start with the Echo F-Back knob at a low setting and gradually increase it. Be aware that high settings can create very loud and sustained feedback, so use caution and be ready to turn it down or mute your signal.
Yes, it requires a standard 9V DC power supply with a center-negativepolarity. Using an incorrect power supply can damage the pedal.
Yes, the pedal can be used with bass guitar. The 'Full' and 'Dark' filter settings are often well-suited for bass, while the 'Bright' setting can be used for more cutting tones.
The pedal is designed to run both effects simultaneously. While you can dial down the intensity of one effect to make the other more prominent, you cannot completely disengage one effect while leaving the other active.
Check all cable connections. Ensure the power supply is correctly connected and providing sufficient power. Verify the correct input and output jacks are being used. Test with different cables.
Ensure a clean power supply is being used, ideally a dedicated isolated power unit. Check that all cables are properly shielded. Move the pedal away from other noisy electronic devices or power supplies.
Adjust the input and output levels if using with other pedals or equipment that have level controls. Ensure the pedal is placed appropriately within your signal chain; some pedals react differently based on their position.
Disconnect power and reconnect. If the issue persists, there may be an internal hardware problem requiring professional service.
Setup:
Connect your instrument's output to the pedal's input using standard 1/4-inch instrument cables. If using stereo, connect both left and right outputs from the pedal to your amplifier or sound system. Power the pedal using a compatible 9V DC power supply (center negative, standard pedal connector). Always ensure the power supply is disconnected before making or breaking connections.
Compatibility:
This pedal is designed for electric guitar and bass, but can also be used with synthesizers, drum machines, and other line-level audio sources. It operates in mono or stereo.
Care:
To clean the pedal, disconnect all cables and power. Use a soft, dry cloth to wipe down the exterior. Avoid using liquid cleaners or solvents, as they can damage the finish and components. Store in a dry environment away from extreme temperatures. Periodically check connections and ensure the pedal is securely mounted on your pedalboard.
