Submersible Dirty Water Pump - 217L/min - 750W Motor - 230V

This pump is designed to handle solids and debris up to 35mm in size.

The pump requires a minimum water depth of 40mm to effectively operate and for the automatic cut-out to function correctly.

The maximum head for this pump is 8 meters.

Yes, while designed for dirty water, it can also be used for clean water applications where submersible pumping is needed.

The pump has a motor power of 750W and operates on a 230V power supply.

After unplugging, rinse the pump with clean water and check the inlet for debris. Ensure it is dry before storing.

The pump has an outlet diameter of Ø38mm, requiring a compatible hose.

Check if the power cord is securely plugged into a functioning 230V outlet. Ensure the water level is sufficient to activate the float switch (at least 40mm). Verify the power supply is active.

Check the inlet screen and discharge hose for any blockages. Ensure the pump is fully submerged and the water source is adequate. Clean any debris from the impeller area if accessible.

This may be due to the automatic low water cut-out feature. Ensure the water level has not dropped below the minimum operating depth. Check for overheating; allow the pump to cool if it feels excessively hot.

There might be debris caught in the impeller or casing. Disconnect power and carefully inspect and clean the inlet and impeller area.