Hozelock Pulsar Plus Pressure Sprayer - 7 Litre

The maximum fill level for the 7-litre model is 5 litres. This is to allow sufficient air gap for proper pressurization.

This sprayer is designed for water-based liquids. It is not recommended for use with oil-based products as they may damage the seals or components.

The nozzle at the end of the lance can typically be twisted to adjust the spray pattern from a fine mist to a more direct stream. Refer to the product manual for specific adjustments.

It is recommended to rinse the sprayer with clean water after each use. A more thorough cleaning of the nozzle and pump may be needed periodically or if blockages occur.

Please refer to the Hozelock warranty information provided with your product or on their official website for the specific warranty period.

It is best to empty the sprayer after use and rinse it thoroughly. Storing chemicals long-term in the sprayer may degrade the plastic components over time.

Ensure the pump assembly is screwed on tightly. Check that the nozzle is not fully closed. Inspect seals for damage and ensure they are properly seated.

Clean the nozzle and filter for blockages. Check if the tank is adequately pressurized. Ensure the liquid level is sufficient.

Verify that the pump assembly is properly tightened. Inspect the O-ring seal on the pump for wear or damage and replace if necessary.

Ensure the large pump handle is being used with two hands. Check for any internal blockages in the pump mechanism. The tank may be over-pressurized; release some air if needed.