Festo 3/2 NC Monostable Air Solenoid Valve M5 190l/min

A 3/2 valve has three ports and two flow paths. It is commonly used to control single-acting pneumatic cylinders, directing air to extend the cylinder and then releasing the pressure to allow a spring to retract it.

Monostable means the valve has one stable position (usually the de-energized state) and requires continuous electrical power to move to and hold its other position. When power is removed, it automatically returns to its stable state.

No, this 3/2 valve is designed for single-acting cylinders. Double-acting cylinders require a 5/2 or 5/3 valve.

'Closed' in '3/2 closed' refers to the state of the ports when the valve is in its de-energized position. In a 3/2 closed valve, the pressure port is blocked, and the cylinder port is connected to the exhaust port.

Consult the valve's datasheet or markings for the specified voltage (e.g., 24V DC, 120V AC) and current requirements. Ensure your control system provides the correct signal.

The standard nominal flow rate for the CPE10-M1BH-3GL-M5 is 190 liters per minute (l/min).

For optimal performance and longevity, filtered and appropriately lubricated compressed air is recommended. Refer to the manufacturer's guidelines for specific air quality requirements.

Check electrical connection, verify solenoid voltage matches power supply, and ensure the control signal is active. Confirm the valve is not internally blocked.

Ensure pneumatic lines are not kinked or obstructed. Check for air leaks that could reduce pressure. Verify the control signal is strong enough.

This is normal operation for a 3/2 valve when shifting. If leaking when de-energized, check for debris on the seat or seal damage.

Ensure the electrical supply to the solenoid is completely removed. Check if there is back pressure on the exhaust port preventing return, or if the internal spring is damaged.