Best current price£7.99from eBay
Shopping.co.uk recommended and popular offers
eBay£7.99Visit shop M10 10mm Blanking Plug For Tap Flexible Pipe Water Inlet
Visit shop
B&Q£12.99Visit shop B&Q - M10 10mm Blanking Plug For Faucet Tap Flexible Pipe Water Inlet
Visit shop2 offers from £7.99 - £12.99
View price history by clicking the chart icon.
The PEPTE M10 Faucet Tap Water Inlet Blanking Plug is an essential component for DIY enthusiasts and plumbers looking to convert or repair bathroom and kitchen mixer taps. Its primary benefit is the ability to securely block off an unused hot or cold water inlet, allowing for single-line operation without the risk of leaks. The main caveat is that it is strictly designed for M10 threading, so users must verify their tap specifications before attempting installation to ensure compatibility.
| Model Part Number | M10 |
|---|---|
| Brand | PEPTE |
No, this plug is strictly for M10 (10mm) connections and will not fit a standard 15mm plumbing line.
Yes, the product comes with two rubber washers to facilitate a secure, watertight installation.
While the rubber washers should provide an adequate seal, plumbers tape can be used as an additional precaution if necessary.
Yes, the material is suitable for both hot and cold water mixer tap inlets.
A 10mm wrench or hex key is recommended for installation.
Ensure the rubber washer is correctly seated and the plug is tightened sufficiently. Check the threads for debris.
Confirm that your tap inlet is M10. If the threads are correct, unscrew and try re-aligning to avoid cross-threading.
Use a deep-reach hex socket or an offset wrench to navigate tight spaces under the sink.
Before installation, ensure the water supply to the tap is completely turned off and the lines are drained. Verify that your mixer tap inlet is indeed M10. To install: 1. Place one of the provided rubber washers into the base of the plug or onto the inlet port. 2. Thread the plug by hand into the inlet to prevent cross-threading. 3. Use a 10mm hex wrench to gently tighten the plug until secure. Do not overtighten, as this may damage the rubber washer. Periodically check the connection for any signs of moisture to ensure the seal remains intact over time.
