Osmo Uv Protection Oil Tints - Red Cedar - 3L

Under normal climatic conditions (23°C / 50% humidity), drying time is approximately 12 hours. Lower temperatures and/or higher humidity can significantly increase drying time.

No, this product is specifically recommended for vertical wood surfaces. It is not designed for horizontal surfaces or areas subject to heavy foot traffic like decking.

Approximately 18 m²/L with one coat. Two coats are required, so the effective coverage is about 9 m²/L for the complete job.

Clean regularly with a damp cloth. For tougher dirt, use Osmo Wash and Care. Avoid abrasive cleaners.

It indicates the level of protection against UV rays that cause wood to grey. This factor effectively slows down the greying process without hiding the wood's natural appearance.

Re-coating is recommended when signs of wear become visible, which can vary greatly depending on the exposure of the wood. It is not typically an annual requirement but rather based on condition.

It's best to apply to bare, clean wood. If there's an existing finish, it should be completely removed or tested for compatibility. Osmo generally recommends application on bare wood for optimal performance.

Ensure consistent application thickness and avoid over-application. Remove excess oil thoroughly before it dries. Ensure the wood surface was uniformly prepared.

This is often due to low temperatures or high humidity. Ensure adequate ventilation and maintain a temperature above 10°C (50°F). Avoid application if rain or heavy dew is expected shortly after application.

The wood surface may be too dense, sealed, or contaminated. Ensure the wood is clean, dry, and properly prepared. For very dense woods, a lighter application might be necessary.

This can occur if the oil was applied too thickly or if moisture got trapped during the drying process. This is usually a surface issue and can often be resolved by lightly sanding and applying a very thin coat.