Best current price£50.37from eBay
Shopping.co.uk recommended and popular offers
eBay£50.37Visit shop Air throttle valve position sensor 6PD 012 754-001 HELLA for AUDI VW SKODA
Visit shop5 offers from £50.37 - £63.76
View price history by clicking the chart icon.
The Hella Intake Manifold Flap Position Sensor (6PD 012 754-001) is designed for automotive technicians and DIY mechanics maintaining Audi, Skoda, and VW vehicles who need an OE-quality replacement to restore precise engine management. This sensor provides critical real-time feedback on flap positioning within the intake system to ensure optimal air-fuel ratios, though professional installation is recommended due to the technical nature of engine calibration and system integration.
| Model Part Number | 6PD 012 754-001 |
|---|---|
| Brand | Hella |
Check your existing part for the OEM number or consult your vehicle service manual to match it with the Hella 6PD 012 754-001 part number.
While it is a bolt-on part, professional installation is recommended due to the need for software recalibration within the vehicle's ECU.
The sensor typically comes as a standalone unit; always check if your specific intake manifold assembly requires a new O-ring or gasket during the replacement process.
The ECU may receive incorrect data regarding flap positions, leading to poor engine performance, reduced fuel economy, or the return of a Check Engine Light.
Hella is a reputable manufacturer that produces parts to meet or exceed original equipment (OE) standards for Audi, Skoda, and VW.
Use an OBD-II scanner to clear existing error codes and perform a throttle body or flap position adaptation reset.
Check that the electrical connector is fully seated and the wiring harness pins are not bent or corroded.
To ensure success, verify your specific engine code against the OEM part number 6PD 012 754-001. During installation, ensure the ignition is switched off and the battery is disconnected to prevent electrical shorts. Use a clean workspace to prevent debris from entering the intake assembly during the swap. The sensor should be tightened to manufacturer-specified torque settings to ensure it does not vibrate loose. After installation, a diagnostic scan tool is typically required to calibrate the sensor and clear existing fault codes from the Engine Control Unit (ECU).
