Best current price£8.45from eBay
Shopping.co.uk recommended and popular offers
eBay£8.45Visit shop AK Interactive Magnet Low Density CA Glue 20g AK12030
Visit shop
OnBuy.com£9.45Visit shop Ak Interactive Magnet Low Density Ca Glue 20G Ak12030 8435568353435
Visit shop3 offers from £8.45 - £10.84
View price history by clicking the chart icon.
This low-density cyanoacrylate glue from AK Interactive is designed for modelers and hobbyists who need precise bonding for small, intricate parts, especially photo-etched metals and tight-fitting components. Its key benefit is its capillary action, allowing it to flow into micro-cracks and gaps for a strong bond. A caveat is that the bottle is intentionally not filled to 100% capacity to ensure proper function, which might initially seem like less product than expected.
| Model Part Number | AK12030 |
|---|---|
| Brand | AK Interactive |
'Low density' refers to the glue's viscosity, meaning it is thin and watery. This allows it to flow easily into very small gaps and spread via capillary action, ideal for precise bonding of thin materials like photo-etched parts.
The bottles are intentionally not filled to 100% capacity. This headspace allows for proper dispensing of the glue and prevents it from curing prematurely within the bottle due to trapped air or moisture.
Yes, this glue bonds well to most plastics commonly used in scale modeling, particularly for attaching smaller plastic detail parts or reinforcing joints. However, its primary strength is with metal components.
Under normal conditions (around 50-70% humidity and 20-25°C), it typically cures enough to handle parts in 5-15 seconds. Full strength cure can take several hours.
Use a fine-tip applicator, a sharpened toothpick, or the nozzle of the bottle itself to apply a tiny amount of glue directly to the edge of the photo-etched part or the joining surface. The low viscosity will allow it to spread into the seam.
It is best for filling very small gaps and micro-cracks where capillary action can draw the glue in. It is not designed for filling larger gaps; a thicker adhesive or a gap-filling putty would be more appropriate for those situations.
Ensure the nozzle is not blocked. If cured glue is visible, carefully clear it with a pin or needle. Check that the bottle is not overheated, as this can cause premature curing. Remember the bottle is not filled to 100% capacity, so ensure there is still liquid glue inside.
Work in smaller sections and have your parts precisely positioned before applying the glue. Use a minimal amount of glue, applying it directly to one surface rather than both. Have a de-bonder or accelerator (if using) ready, but use with caution.
Ensure surfaces are clean and free from oils, dust, or release agents. Apply a thin, even layer of glue. For metal parts, ensure they are properly de-greased. Consider using an accelerator for faster, stronger bonds on difficult surfaces, but test first.
Ensure adequate ventilation, as moisture in the air helps cure cyanoacrylate. For faster curing, consider using an accelerator product designed for CA glues. Avoid applying in extremely humid or dry conditions.
Setup: No specific setup is required. Ensure the surface you are bonding is clean, dry, and free from dust or grease for optimal adhesion. For very fine applications, consider using a fine-tip applicator or a toothpick.
Compatibility: This glue is primarily designed for bonding metals, especially photo-etched parts. It also bonds well to most plastics commonly used in scale modeling. Avoid using on fabrics, porous materials, or materials sensitive to cyanoacrylates.
Care: Store the glue in a cool, dry place away from direct sunlight. Keep the cap tightly sealed when not in use to prevent premature curing. Clean any excess glue from the bottle tip immediately after use. To remove uncured glue from skin, use a specialized cyanoacrylate remover or warm soapy water. For cured glue, gentle abrasion might be necessary.
