9 pins Ceramic Vacuum Tube Socket Valve 53mm Aluminum Shield - Pack of 3
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
Designed for audiophiles and electronics technicians, this 53mm aluminum shield cap provides essential thermal management and mechanical protection for 9-pin vacuum tubes. It is an ideal solution for those looking to extend the lifespan of their tubes in high-performance equipment like preamplifiers and guitar amps, though users should ensure their specific chassis has sufficient vertical clearance for the 53mm height.
All features
| Model Part Number | DOESNOTAPPLY |
|---|---|
| Brand | uxcell |
Extended Product Information
FAQs
Will this fit a 12AX7 tube?
Yes, this shield is fully compatible with 12AX7 vacuum tubes.
What is the total height of the shield?
The shield has a total height of 53mm.
Does this require screws to install?
The unit uses a snap-on design for the socket base, but ensure your chassis mounting points align with the 28mm hole spacing.
How many shields are in one package?
Each package contains 3 shield units.
Is the material conductive?
Yes, the aluminum construction is conductive; ensure the shield is properly grounded if your circuit design requires it.
Troubleshooting
Shield does not snap onto the socket base
Ensure the base is compatible with standard 9-pin mounts and there are no obstructions such as excessive solder on the mounting points.
Tube rattles inside the shield
Check that the internal spring is properly tensioned and that the shield is fully seated on the base.
Pros and Cons
Pros
- Efficient heat dissipation via integrated spring
- Compatible with a wide range of popular 9-pin tubes
- Resistant to rust and oxidation
- Easy snap-on installation
Cons
- Height of 53mm may not fit low-profile chassis enclosures
- Requires specific 28mm hole spacing on existing sockets
- Non-adjustable tension for different tube diameters
Setup, Compatibility & Care
To install, align the shield's snap-on mechanism with the tube socket base and apply gentle, even pressure until it locks into place. Verify that the 3mm installation holes align with your board or chassis layout.
Compatibility Note: This product is intended for standard 9-pin sockets. Always confirm the distance between your mounting points is exactly 28mm before attempting installation.
Care: The aluminum surface can be cleaned with a dry, microfiber cloth to remove dust. Avoid using abrasive cleaners or liquid solvents, as these may damage the finish or seep into the socket pins, causing electrical shorts.