Unslotted Pop Up Basin Waste - Architeckt

No, this is an unslotted basin waste and is specifically designed for basins *without* an overflow hole. Using it on a basin with an overflow will cause water to leak out of the overflow.

The Architeckt Unslotted Pop Up Basin Waste comes with a 2-year guarantee against manufacturing defects.

Typically, you push down on the stopper to close the drain and push down again (often in a slightly different way or until it clicks) to open it. The specific action might vary slightly, but it's designed for simple push-to-operate functionality.

The stopper (cover) is made of ceramic, and the tube is made of brass.

This basin waste has a G 1 1/2 inch connection, which is standard for most basin traps. It is not typically designed for use with a bath trap, which has different dimensions and connections.

Clean the ceramic surface with a soft, damp cloth and mild soap if necessary. Avoid using abrasive cleaners, scouring pads, or harsh chemicals, as these can damage the gloss finish.

Ensure the plastic nut is tightened sufficiently. Check that the rubber washer and plastic/brass washers are correctly seated. Reapply plumber's putty or sealant around the basin hole if necessary.

Check for debris around the stopper. Unscrew the pop-up rod and clean the stopper and the inside of the waste body. Ensure the pop-up rod is correctly adjusted.

The waste pipe or the basin trap may be blocked. Clean out any debris from the basin waste itself, and check and clean the basin trap and connecting pipework.

Soap scum or mineral deposits may be causing stiffness. Unscrew the pop-up rod and clean the stopper, rod, and the inside of the waste body with a mild cleaner. Lubricate lightly if needed.