Silberschnitt Spare Pressure Plate and Bar for Glass Cut Running Pliers - Model 700.0

This set includes both the genuine Silberschnitt pressure plate and the corresponding bar specifically for the 700.0 model of glass cut running pliers.

The approximate weight of this spare set is 0.03968320716 pounds.

No, this spare pressure plate and bar set is designed exclusively for the Silberschnitt 700.0 glass cut running pliers (model BO 700.0).

Replacement frequency depends on usage. Inspect the components regularly for wear, and replace them when you notice a decrease in cutting accuracy or visible damage.

These genuine Silberschnitt parts are manufactured by Bohle.

It is recommended to use genuine Silberschnitt parts to ensure proper fit, performance, and longevity of your glass cutting pliers. Generic parts may not offer the same precision or durability.

Ensure the pressure plate and bar are installed correctly and securely. Check if the cutting wheel on the pliers is worn or damaged and requires replacement.

Verify that you are using the correct model (700.0) and that no debris is obstructing the installation points. Consult the tool's manual or manufacturer for specific installation diagrams if needed.

Check that all securing screws or mechanisms are fully tightened. If the issue persists, there might be an incompatibility or a defect, and replacement may be necessary.