Zinc Galvanising Spray Paint - Pro-Kleen - Silver

The spray is touch dry in approximately 30 minutes, depending on temperature and humidity.

Yes, it can be used on other ferrous metals as a protective primer and topcoat, providing excellent rust and corrosion resistance.

The surface must be clean, dry, and free from grease, oil, and rust. Lightly abrading the surface with sandpaper will significantly improve adhesion.

Yes, this spray acts as a primer and topcoat and can be overpainted with most types of paint once dry, if desired for aesthetic reasons.

For optimal protection and color match, at least two thin, even coats are recommended, allowing adequate drying time between each.

This spray is designed for touch-ups and repairs, not as a replacement for the full hot-dip galvanizing process on new items.

Ensure the can is shaken thoroughly. Try clearing the nozzle by inverting the can and spraying briefly. If the problem persists, the nozzle may be blocked; try cleaning it or replacing the can.

The surface may not have been adequately prepared. Ensure the surface was clean, dry, and free from contaminants before application. Lightly abrading the surface can improve adhesion.

Color appearance can vary due to lighting and the original galvanization process. Apply thin, even coats for the best match. Allow the paint to fully cure before final assessment.

The can may be held too close to the surface, or too much paint was applied in one coat. Apply in multiple thin coats from the recommended distance (15-25 cm).