K2 Brake Caliper Paint - Green - 400ml

Clean the surface with 240-360 grade sandpaper, then degrease thoroughly to remove all contaminants. Proper preparation is crucial for adhesion and durability.

Yes, you can paint them without full disassembly, but you must meticulously mask off all surrounding components, including the rotor, brake lines, and sensors, to prevent overspray.

The paint is touch-dry in 30-60 minutes at 20°C. However, it requires a full 12 hours at 20°C to cure completely.

Paint on friction surfaces can significantly reduce braking performance and may require extensive cleaning or replacement of affected parts. Always avoid contact with these areas.

It is recommended to apply 2-3 thin coats, with approximately 10 minutes drying time between each coat.

The paint is formulated for high temperatures, but for extreme track use, ensure it meets the specific demands of your driving conditions. Always follow application instructions carefully.

Use a damp cloth for cleaning. Avoid using harsh chemicals, abrasive materials, or high-pressure sprays directly on the painted surface, especially within the first few days after curing.

Ensure the surface was properly cleaned, sanded, and degreased before application. Re-prep the surface and reapply.

Applied coats too thick or too close. Shake can better and apply thinner, even coats from the recommended distance, allowing proper flash-off time between coats.

Ensure the can was shaken sufficiently. Clear the nozzle by inverting the can and spraying for a few seconds. If blocked, try cleaning the nozzle with a solvent.

Ensure adequate coats were applied and that the surface was properly prepared and clean. Ambient temperature and humidity can also affect final appearance.